HOW TO USE THE MK 12 MOSQUITO TRAP GUARDIAN.

DIRECTIONS FOR ASSEMBLY AND USE

Read before unpacking and operating the Lentek Mosquito Trap. The Mosquito Trap requires 120V AC and is for Outdoor Use Only.

FOR YOUR SAFETY:

1. Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of the Mosquito Trap or any other appliance.
2. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1-1998 for US and with the CANI-B149 for

ASSEMBLY:

Step1: Assemble the support column to the base .Place the base on a flat surface. Insert the support column with the slotted side down as shown. Press in firmly.
Step 2: Attach the Burner Unit to the top of the support column Attach the burner unit to the top of the support column as shown. Press the tabs on the sides of the support column to insert it into the hole in the burner unit. Make sure that BOTH tabs pop up through the holes in the bottom of the burner unit.
Step 3: Select the location where the Mosquito Trap will be installed and hammer the stakes in the ground to properly secure it.
Step 4 :Attach the Power adapter.
Sstep5: Place the propen tank on the Base.
Step 6: install the Mosquito Receptacle to the trap.

SHUTTING OFF THE MK 12 Mosquito Trap Guardian:

Step 1: Close the gas valve on the propane tank by turning it clockwise.
Step 2: Look through the window on the side of the burner unit and verify that the flame has gone out. It may take up to 30 seconds to burn the gas in the line and for the flame to go out

OPERATION:

1. Plug in the adapter’s power cord to an approved "Outdoor Use" extension cord and in accordance with the safety instructions on page 12.
2. Plug the adapter end into the socket on the underside of the trap body as shown.
3. Locate the ON/OFF switch on the side of the main body. This activates the heater and the vacuum fan. Turn it to the "ON" position.
4. Leave the Mosquito Trap turned on and the burner lit. The Mosquito Trap will operate for 4 to 6 weeks continuously capturing mosquitoes on a single tank of propane.

MAINTENANCE:

Check the capture cup on a regular basis depending on how many mosquitoes are being trapped. Start by checking the trap once a week and adjust according to the catch. Use only clean water to rinse the cup, do not use any chemical or soap as the fragrance may keep repel mosquitoes from the trap. In many cases, the large amount of airflow through the cup, grinds captured mosquitoes against the metal mesh, breaking them into small pieces, which are then blown through the screen. Mosquito Fact: About 800 dead mosquitoes equals
1 tablespoon! One ounce equals over 65,000 dead mosquitoes!
2. Refill the propane tank, as necessary when using continuously. Turn off the unit and disconnect the electrical supply before changing the tank.
3. There is a replaceable fuse located on the bottom of the trap body. Check this fuse if the Mosquito Trap does not turn on when properly plugged into the approved 120V AC electric adapter. Replacement fuse is 250V / 2Amp).
4. Keep the area around the Mosquito Trap clear and free from combustible materials, gasoline, and any other flammable vapors and liquids.